Embedded
Добавлено: Ср окт 31, 2007 3:33 pm
I have practical experience for working in analog, digital, firmware area. I can design hardware, route PCB (inc. for SMPS, low-noise or high-speed), I can soldering and debug prototype. I can write and debug firmware and write testing software for PC for Linux or Windows.
Analog: Sensors, motors, SMPS (incl. high-voltage and high power), analog signal processing, amplifiers etc.
Digital: ARM7, TMS320F28, AVR, 8051, FPGA, SDRAM, TFT.
Project engineer: I can make small project, or I can make hardware, “drivers” and software for testing. After I can support and consult.
Software/firmware: C, C++,Assemblers, Verilog, Mathlab.
OS: Linux, uCOS-II, QNX, Windows, PalmOS3.5
http://one.fsphost.com/artembond/ArtemBondarenko.pdf
Analog: Sensors, motors, SMPS (incl. high-voltage and high power), analog signal processing, amplifiers etc.
Digital: ARM7, TMS320F28, AVR, 8051, FPGA, SDRAM, TFT.
Project engineer: I can make small project, or I can make hardware, “drivers” and software for testing. After I can support and consult.
Software/firmware: C, C++,Assemblers, Verilog, Mathlab.
OS: Linux, uCOS-II, QNX, Windows, PalmOS3.5
http://one.fsphost.com/artembond/ArtemBondarenko.pdf